• Voltage Rating: 250V AC
• UL 94 flammability rating: V-0
• CE-marked (Low Voltage Directive)
• Standard color: black
  

• To be installed by qualified personnel only. Failure to wire as instructed may cause personal injury or damage to equipment! For factory assembly only.
• Remove outer jacket on cord 20mm, strip conductors 5mm
• Tighten wire clamp screws with a torque of 0.8Nm
• Tighten strain relief screws and cover screws with a torque of 0.5Nm
• Perform electrical tests and cord retention force tests

Part number: H1061X8880A3
Description: 10A snap-in type* inlet for cold conditions, per IEC320/C14

• 4.8mm (0.188") quick-disconnect (Q.D.) terminals**
• For panel thicknesses from 0.8mm to 2.0mm Panel cut-out

*Also available with mounting flanges (types H6061, H6067)
**Also available with 6.3mm (0.250") quick disconnect terminals (part number H1061X9990A3)

Part number:
H1064XBB21A3005 (double fused)
H1064XB221A3005 (single fused)
Description: 10A snap-in type* inlet for cold conditions,
per IEC320/C14 with fuse holder for 1 or 2 fuses
5x20mm (6.3A max)

• L + N connected to fuse holder (double fused type)
• Solder terminals (L=4.8mm) on ground and fuse holder*
• Panel thickness from 1mm - 3mm
• Panel cutout dimensions: 26.8mm x 31.5mm

*For 4.8mm or 6.3mm Q.D. terminals on the fuse holder ask for type H1094
Type H1062 comes flanged, otherwise has similar construction.
Type H1074 is a snap-in type and has a unipolar switch (unfused)

• 6.3mm Q.D. terminals
• Panel thickness: 3mm (can be supplied for panel thickness from 1.0mm - 4.0mm, please specify.)
• Panel cut-out dimensions: 27.7mm x 20.2mm

• 6.3mm Q.D. terminals
• Panel thickness: 1.5mm(can be supplied for panel thickness from 1.0mm - 3.0mm, please specify.)
• Panel cut-out dimensions: 32.3mm x 24.7mm

Type H5098 comes with mounting flanges, otherwise has the same characteristics.

• 6.3mm Q.D. terminals
• Mounting flange with through holes*
• Panel cut-out dimensions: 23.5mm x 16.0mm

*Also available with countersunk holes (part number H5091X9990A1)

• 4.8mm Q.D. terminals on L,N + G, fuse holder and switch
• Panel thickness: 1.0mm to 2.0mm
• Panel cut-out recommendation:
  -Panel thickness up to 1.5mm:60.8mm x 27.2mm
  -Panel thickness >1.5mm: 61.5mm x 27.2mm
  

*Also available as flange mount type. Use of fuses per IEC127-2 recommended. Call for different switch types (unipolar, illuminated) and terminals.